The number of watts used in a circuit is equal to the volts squared divided by the ohms. Find the wattage used in the circuit shown. Round the answer to the nearer tenth.

Fill in the blank(s) with the appropriate word(s).


7692.3

Trades & Technology

You might also like to view...

One of the most common terminals on the circuit board, the ____________________ terminal is usually found with the wire wrapped around it two or three times.

Fill in the blank(s) with the appropriate word(s).

Trades & Technology

If the maximum frequency present in an analog waveform in the accompanying image must be less than _______ µs.


Fill in the blank(s) with the appropriate word(s).

Trades & Technology

While having a discussion, Technician A says that an ohmmeter should be used to test an O2 sensor. Technician B says that you should not use an ohmmeter to test an O2 sensor. Who is correct?

A. A only B. B only C. Both A and B D. Neither A nor B

Trades & Technology

When copper is being brazed to steel, _____

a. the technique is identical to brazing copper to copper b. more heat is applied to the steel fitting c. a filler metal with a high phosphorus content is best d. flux and a filler metal with a high silver content is used

Trades & Technology