Technician A says that the starter motor used to crank diesel engines can draw up to 400 amps of current. Technician B says that high resistance on the insulated side of a starter motor circuit would cause higher than specified starter motor current draw. Who is correct?
A. Technician A only
B. Technician B only
C. Both A and B
D. Neither A nor B
Answer: A
You might also like to view...
A bipolar BLDC motor with k? = 1.0 Vs is running at regenerative braking mode. The dc voltage source is 180 V. The armature resistance of the motor is 1.0 ?. The measured current is 10 A and is continuous. Compute the developed torque, the power delivered to the source, and the speed of the machine.
What will be an ideal response?
The following statements are all correct EXCEPT ________
A) Waste-spark systems use a signal from the PCM once the engine is running. B) Waste-spark systems do not need a timing signal from the PCM when cranking the engine. C) No ignition system uses the PCM to control ignition timing. D) Up-integrated ignition controls use the PCM to control ignition timing.
In the article “Influence of Crack Width on Shear Behaviour of SIFCON, the maximum shear stress ? of a cracked concrete member is given to be 
, where 
is the maximum shear stress for a crack width of zero, w is the crack width in mm, and k is a constant estimated from experimental data. Assume 
. Given that =50 MPa and w=1.0 mm, both with negligible uncertainty, estimate ? and find the uncertainty in the estimate.
What will be an ideal response?
The paste command normally sends its output to ____.
A. stdout B. null C. stderr D. the file indicated as an argument