In using spray-on fire protection for floor and roof assemblies, we generally apply the protection on roof decks and supporting beams, but in the case of the floor decks, we generally apply it only on the supporting beams, leaving the floor deck without spray-on protection. Explain the reason.
What will be an ideal response?
See the Instructor's Manual (IM).
You might also like to view...
The __________ on a typical conduit hand bender head is where you will place the bending mark when doing a stub-up bend.
a. arrow b. rim notch c. star point d. hook
When testing a normally open relay contact with a de-energized coil it should measure:
A) Infinite ? or OL on digital meters. B) 0?. C) Some measurable resistance depending on the design of the relay. D) None of the above.
If you were to type the following into a cell, what would be the result in Excel? =2+3*(4+5)
a. 25 b. 29 c. 19 d. 20
What shop tools can be used to test inlet restriction on primary fuel filters?
A. Negative pressure gauge or manometer. B. Fuel system scan tool. C. Master pyrometer. D. Positive pressure gauge.