What are the steps involved in static timing the ignition system?
What will be an ideal response?
1. With the number 1 cylinder on its compression stroke, align the timing indicator at the crank pulley to the desired timing specification.
2. Install the distributor with the rotor pointing to the number 1 plug cable.
3. Rotate the distributor body until the armature pole piece aligns with the permanent magnet.
4. Tighten the distributor holddown.
You might also like to view...
What are the three types of split phase motors?
What will be an ideal response?
Technician A says power brakes were developed because of increased vehicle weight and increased speed capabilities. Technician B says disc brakes systems all operate with power assist. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians D) Neither technician
Compared to a single V-groove weld, a double V-groove weld _____
a. has greater distortion b. has equal distortion c. requires twice the weld metal d. requires half the weld metal
Rooftop units should be leveled when they are installed so that
A) the airflow will travel in the right direction through the evaporator B) the oil will return to the compressor C) the refrigerant will travel through the system correctly D) the condensate can drain properly