Safety, quality, and production on a project must be _____.

a. inseparable
b. evaluated
c. prioritized
d. adjustable


a. inseparable

Trades & Technology

You might also like to view...

Using the rational formula, determine the runoff rate for a storm of 100-year frequency. Use Table 16.2 for runoff coefficients. Assume that the rainfall intensity curves in Figure 16.2 are applicable to this drainage area and the following land characteristics apply. Use Figure 16.4 to calculate average velocity using "fallow or minimum tillage cultivation" ground cover. Overland flow length = 0.5 miles. Average slope of overland area = 2%

A 196-acre rural drainage area consists of four different watershed areas as follows: Steep grass covered area = 35% Cultivated area = 15% Forested area = 40% Turf meadows = 10% What will be an ideal response?

Trades & Technology

A driver complains that his trailer marker lights continually cycle on-and-off, being illuminated for a couple of minutes, then quitting for up to five minutes. What type of circuit protection device is likely installed in the trailer marker light circuit?

A. blade type fuse B. ballast resistor C. SAE #1 circuit breaker D. SAE #2 circuit breaker

Trades & Technology

____________________ are used to represent specific material section line symbols in the sectional view.

Fill in the blank(s) with the appropriate word(s).

Trades & Technology

The unit of measurement of an AC voltage measured on an oscilloscope is ____.

A. peak B. peak to peak C. average D. rms

Trades & Technology