Which of the following conditions can cause a steady-state error to develop?
A. The system gain is too low.
B. The system gain is too high.
C. The load the actuator is driving is too large.
D. The system responds too fast.
E. Both a and c are correct.
Answer: E
You might also like to view...
An open circuit voltage test may be used in place of:
A. A battery leakage test B. A battery hydrometer test C. A battery capacity test D. All of the above
On a hydraulically-controlled automatic transmission, what is used to measure engine load?
A) Governor B) Throttle valve (TV) C) Vacuum modulator D) Either B or C
The depth of penetration of flare-formed groove welds is assumed to extend to ____.
A. the ends of the members B. the tangent points of the members C. the distance equal to the width of the members D. the closest flush surface of the members E. none of the above
A 220 ? 1/2 W resistor has burned open, so you look in your parts box to find a replacement. Which one of the following resistors could you use to repair the circuit?
A) 220 ? 1/8 W B) 2200 ? 1/2 W C) 220 ? 1/4 W D) 220 ? 1 W