What is considered a long-line application for residential air conditioning?

A) Lines exceeding 100 ft in length or with a vertical rise of more than 30 ft
B) Lines exceeding 50 ft in length or with a vertical rise of more than 10 ft
C) Lines exceeding 80 ft in length or with a vertical rise of more than 20 ft
D) Air-conditioning systems can run lines for nearly any length with no problems.


C

Trades & Technology

You might also like to view...

TechnicianA says the best way to check a power tool is to plug it in and try to use it. TechnicianB says the power tool should be inspected before each use. Who is correct?

A. A only B. B only C. Both A and B D. Neither A nor B

Trades & Technology

The step response of an RLC circuit is given by Given that iL(0) = 3 A and vC(0) = 24 V, solve for vC(t) and IC(t).

What will be an ideal response?

Trades & Technology

The internal piston in the reversing valve is moved from one side to the other by:

A) A stepper motor. B) Pressure difference. C) A gear motor. D) Permanent magnets attached to the ends of the piston.

Trades & Technology

During an AC performance test, an R-134a air conditioning system has a measured center duct outlet temperature of 41 degrees F. The manifold gage set shows low side pressure between 21-35 psi. The high side pressure ranges from 175-210psi. Intermittantly, the duct outlet temperature will rise to 60 degrees F and the low side gage show a vacuum when this happens. Shop Temperature is 72 degrees F. What is most likely the cause?

a. The system contains moisture causing a restriction in the TXV b. The system contains air with the refrigerant c. The TXV is defective and allowing too much refrigerant to flow d. The system is operating normally

Trades & Technology