A DMM set to read DC volts is connected across terminals 6 and 14 of the DLC. The meter reads zero volts at all times, key on or key off. This indicates ________
A) A CAN BUS shorted to ground B) A low temperature condition
C) Bad UART output D) Headlights are OFF
A
You might also like to view...
To maximize the efficiency of water usage, it is important that make sure the soil is tilled as shallow as possible and to increase aeration, drainage, and nutrient- and waterholding capacity of the soil
Indicate whether the statement is true or false
According to the adaptation model, one of the strategies that a firm can use is
a. prospecting b. differentiating c. declining d. cost leadership e. None of these.
As gage blocks are disassembled and replaced, they are:
A) Coated with preservative B) Handled only with cloth or tissue C) Thoroughly cleaned D) All of the above
When hysteresis is present in intermittent controllers, which of following statements is false?
A) The hysteresis eliminates the dead zone in on-off controllers. B) The hysteresis causes the controller to drive the PV output value above the set point when the controller is on. C) Two-position control adds hysteresis to the on-off controller operation. D) The hysteresis lets the PV fall below the set point when the controller is off.