The command used to draw circles in isometric views is:

a. ISOCIRCLE
b. ELLIPSE
c. ISOPLANE
d. CIRCLE


b. ELLIPSE

Trades & Technology

You might also like to view...

The term quarter-sawedmeans _____.

a. only one-fourth of the tree is used b. the lumber is classified as softwood c. the lumber is cut with the growth rings at an angle greater than 45 degrees d. the log is cut into four equal lengths before it is cut into lumber

Trades & Technology

Use magnitude and frequency scaling on the circuit of Fig. 14.79 to obtain an equivalent circuit in which the inductor and capacitor have magnitude 1 H and 1C respectively.

Trades & Technology

Connecting a ________ inductor in ________ with a 70 mH inductor produces a 100 mH inductance

A) 233 mH, parallel B) 30 mH, series C) 233 mH, series D) 30 mH, parallel

Trades & Technology

If bc=3 and ac=5, what is ab?

Fill in the blank(s) with the appropriate word(s).

Trades & Technology