What would happen if oil or water (coolant) was at the bottom of a dry hole in the bolt when the head bolts are installed and torqued?
A) Block could crack
B) Bolt would break
C) Liquid would be forced upward and out of the hole
D) Either B or C
A
You might also like to view...
Find the volume of water, in cubic feet, that can be held in a semicircular-shaped tank with a diameter of 6’, two flat sides that are each 14’, and a height of 2’. All dimensions are inside dimensions. Round the answer to the nearest tenth.
A noncontinuous load of two 120V outlets for heavy-duty lamp holders would have a load of _____.
a. 240VA b. 360VA c. 600VA d. 1,200VA
A material that is weak in tension is
A) strong in shear. B) weak in shear. C) no relationship between the shear and tensile strengths of a material.
To properly install heat-shrink insulators, ___
a. slip the insulator over the connector and apply heat for a few seconds b. apply heat for a few seconds and then install the insulator c. tape the insulator in place before applying heat d. use PVC cement on the insulator before applying any hea