The minimum size of an equipment grounding conductor for feeder taps is determined
A. based upon the rating of the overcurrent protection at the load end of the feeder tap.
B. based upon the ampacity of the tap conductors from Table 310.15(B)(16).
C. based upon the ampacity of the feeder to which the tap conductors are connected.
D. based upon the rating of the overcurrent protection on the supply side of the feeder
conductor.
D. based upon the rating of the overcurrent protection on the supply side of the feeder
conductor.
You might also like to view...
? Identify and state the historical significance of Franklin D. Roosevelt.
What will be an ideal response?
When blowing through the vacuum supply hose, if air passes through the check valve into the booster ________
A) Replace the check valve B) Replace the booster C) Replace the vacuum pump D) The check valve is functioning properly
Find current I? in the circuit of Fig. 13.91.
 figure 1.png)
A high-speed CAN BUS communicates with a scan tool through which terminal (s)?
A) 6 and 14 B) 2 and 5 C) 7 and 15 D) 4 and 16