Most likely gripper to use if circular parts need to be centered when picked up
A) Pin and mandrel grippers
B) Finger and bellows grippers
C) Parallel and angular grippres
D) Vacuum grippers
E) All of the above
C
You might also like to view...
What may be the result of poor atomization of liquid fuels?
A. Coking B. Fouling C. Overheating D. Pooling of liquids inside the firebox
Which of the following could be a quasi-equilibrium process?
A) Mixing a fluid in a rigid volume B) Combustion of the air-fuel mixture in a cylinder C) Expansion of gases in a piston-cylinder arrangement D) Heating air in a cylinder with a resistance heater
Technician A says that a transmission output yoke retaining nut can be final torqued using a 1-inch drive shop air gun. Technician B says that the same nut can be safely removed using a 1-inch drive shop air gun. Who is correct?
A. Technician A only B. Technician B only C. Both A and B D. Neither A nor B
Describe the operation of OSHA.
What will be an ideal response?