All of the following statements are true EXCEPT:
A. Low-amperage circuits, usually 20 amps or less, can be tested directly with the DMM.
B. To measure amperage with the DMM, you must move the positive test lead to the amperage jack.
C. The amperage test setup places internal amperage fuse in series with the positive and negative meter leads.
D. For the DMM to measure amperage, it must be placed in series with the circuit.
Answer: A
You might also like to view...
Technician A says the ignition timing must retard as RPM increases. Technician B says ignition timing is retarded under maximum load. Who is correct?
A. Technician A B. Technician B C. Both A and B D. Neither A nor B
The maximum decibel level considered for continuous exposure over 8-hour days without protection is:
What will be an ideal response?
Since the rental rate quoted by a contractor to another party for the use of the contractor's equipment is, in a sense, a kind of bid, the same considerations should be applied to the markup on the rental rate as are applied to markup on any of a contractor's bids.
Answer the following statement true (T) or false (F)
Which valve is controlled by the position of the gearshift selector?
A) Manual B) Detent C) Pressure control D) None of these are correct.