A ____ converts the output of a sensor into a standardized signal.
A. transmitter
B. transducer
C. either a or b
Answer: C
You might also like to view...
Select the list of conductors that begin with the smallest wire and go up.
a. 18 AWG, 14 AWG, 3/0, 1/0 b. 14 AWG, 18 AWG, 3/0, 1/0 c. 18 AWG, 14 AWG, 1/0, 3/0 d. 14 AWG, 18 AWG, 1/0, 3/0
More complex trim shapes and greater quantities of trim are typically used in buildings _____
a. used for commercial purposes b. of traditional design c. in the northeastern states d. of contemporary design
If forced to move up a steep slope, the gear that should be used before slowly engaging the clutch is _____
a. the highest gear possible b. the lowest gear possible c. high reverse gear d. low reverse gear
Normally, a single part in an assembly is drawn alone on one sheet without any portion of the assembly shown. In some applications, it is necessary to show a part or parts that are next to the part being detailed. This is the related part method. Describe the related part method.
What will be an ideal response?