The depth of cut for a finish cut should be approximately ________ of an inch?
A) .005 B) .020 C) .060 D) .080
B
You might also like to view...
Clash detection software identifies:
A. ?potential conflicts in materials compatibility. B. ?potential conflicts in subcontractor scheduling. C. ?the locations of building elements that could overlap compatibly. D. ?the locations of building elements that could intersect incompatibly.
Answer the following statements true (T) or false (F)
1 Using the wrong lubricant can result in serious and costly equipment damage and, in some cases, catastrophic failure, fire, explosion, and injury to personnel. 2 One advantage of a chain over a belt driver that there is no slippage between chain and sprocket teeth. 3 Interlock systems are designed to prevent rotating equipment from sustaining serious damage when upset conditions or component failures occur. 4 Equipment vibration on large rotating equipment can be an indication of a potentially serious problem. 5 For motors, fast-acting fuses must be used because there is a large current in-rush when a motor starts.
In a solvent, the molecules of one substance dissipate among the molecules of another substance
Indicate whether the statement is true or false
If it were possible to connect a 1-pound disposable refrigerant can to the high side of an A/C system, what would most likely result?
A. contents of the can would immediately be sucked into the system B. refrigerant on high side would be pulled into the can C. can might explode D. high side hoses would explode