When producing a shop drawing, the first step is to _____.
a. determine the standard symbols for use, based on the specifications
b. select a scale two to four times larger than the scale used for the design drawing
c. properly locate all access doors, boots, fire dampers, and registers
d. locate all ducts by dimensioning from the center line to the nearest column
b. select a scale two to four times larger than the scale used for the design drawing
You might also like to view...
Digital to Binary to Digital Conversions. Consider the following worksheet that converts the specified decimal digit in A3 into its 4-bit binary representation in C3:F3 and the specified 4-bit binary sequence in A7:D7 into its decimal equivalent in F7.
a. What is the Excel formula in E3?
b. What is the Excel formula in F7?
The part that is MOST-Likely a rear seal is the:
A. flywheel bolt B. rope seal C. clutch D. gasket
How does FSO overcome scintillation?
What will be an ideal response?
Large manufacturing facilities can benefit from the use of which technology since it relieves them from having to install very long cables to access remote sensors?
A. Bluetooth B. WLANs C. NFC D. ZigBee