Form tolerances are used to control straightness, flatness, circularity, and ____.
A. angularity
B. cylindricity
C. symmetry
D. parallelism
Answer: B
Trades & Technology
You might also like to view...
In the technique known as _________, plant materials from two separate plants are joined to form one plant
Fill in the blank(s) with correct word
Trades & Technology
What are two common behavioral disorders seen in captive hedgehogs?
What will be an ideal response?
Trades & Technology
High pressure hoses have to be used on the high pressure side of the power steering system because pressures can reach as high as ________
A) 2500 psi B) 750 psi C) 1500 psi D) 200 psi
Trades & Technology
Dropping the hip is required because the top corners of a hip rafter will sit ________ the plane of the roof
A) Slightly lower than B) Slightly higher than C) Significantly lower D) At the same level as
Trades & Technology