Constraint-based assemblies often have global parameters defined to assist in developing mating features of different parts. Identify which features of the two (mating) parts described in the following drawings would be candidates for shared parameters. (Note the different plotted scale of the parts!)
What will be an ideal response?
Centering constraints and diameters for the holes. The dovetail also needs constraining for location and radius.
You might also like to view...
An angle measuring 26° 42’ 36” is divided into 4 equal parts. Find the degrees, minutes, and seconds in each part.
What will be an ideal response?
When should you approach the customer about the potential cost of a required part?
A) Just before you leave the job B) You should let them find out when they receive the bill. C) Before replacing the part D) On the phone after you have left
On a standard SAE relay, which two terminals are used to energize the coil or control circuit?
A. 1 and 2 B. 2 and 3 C. 3 and 4 D. 4 and 5
What were the five major innovations that made the American System possible?
What will be an ideal response?