The production of agricultural animals has been criticized by some as being harmful to the environment.
Answer the following statement true (T) or false (F)
True
You might also like to view...
A dropout plate can be used when the cable exits the tray _____.
a. simply upward b. into a conduit clamped to the siderail c. into a conduit attached to the tray bottom d. between the rungs
The tall building in Figure P9.49 (see next page) is constructed of structural steel. The exterior columns, which are uninsulated, are exposed to the outside ambient temperature. To reduce the differential vertical displacements between the interior and exterior columns due to temperature differences between the interior and exterior of the building, a bonnet truss has been added at the top of the building. For example, if a bonnet truss was not used to restrain the outer columns from shortening in the winter due to a 60°F temperature difference between the interior and exterior columns, points D and F at the top of the exterior columns would move downward 1.68 in. relative to the top of the interior column at point E. Displacements of this magnitude in the upper stories would produce
excessive slope of the floor and would damage the exterior facade.
If the temperature of interior column BE is 70°F at all times but the temperature of the exterior columns in winter drops to 10°F, determine (a) the forces created in the columns and the truss bars by the temperature differences and (b) the vertical displacements of the tops of the columns at points D and E. Slotted truss connections at D and F have been designed to act as rollers and transmit vertical force only, and the connection at E is designed to act as a pin.
The shear connections between the beam webs and the columns may be assumed to act as hinges.
Given: E = 29,000 kips/in. 2 . The average area of the interior column is 42 in. 2 and 30 in. 2 for the exterior columns. The areas of all members of the truss are 20 in. 2 . The coefficient of temperature expansion ? = 6.5 × 10 ?6 (in./in.)/°F. Note: The interior columns must be designed for both the floor loads and the compression force created by the temperature differential.
The symbol for a bevel groove weld is ____.
A.
B.
C.
D.
Repetitive features can be located by noting the number of times a dimension is repeated, and giving numerous typical dimensions as well as the total length as reference.
Answer the following statement true (T) or false (F)