A bathtub that is usually rectangular, open, and unfinished on both ends and the back and has a finished apron along the front is called a
A. corner tub
B. leg tub
C. whirlpool tub
D. recessed tub
Answer: D
You might also like to view...
Answer the following statement(s) true (T) or false (F)
1. Circularity is a perfect condition. 2. Surface texture deviations are included in a cylindricity tolerance zone. 3. Rule #1 is a direct form control. 4. Where a cylindricity tolerance is applied to a cylindrical surface, the tolerance zone applies along the entire length of the cylinder. 5. A cylindricity gauge is an instrument used to measure cylindricity deviation.
The ____ section of the NTE catalog lists part numbers in alphanumeric order.
a. front b. middle d. decoupling d. supplemental
What letter does the Newer ASME standards for knurls and knurling use to precede the pitch?
What will be an ideal response?
On a commercial refrigeration system with hot-gas defrost, what does the compressor do during the defrost cycle?
A) It operates to provide the heat for defrost. B) It runs backwards to pump hot gas into the evaporator. C) It cycles like it normally would. D) It shuts off.