Technician A says that a minor overhaul includes performing a valve job. Technician B says that a minor overhaul includes replacing the pistons. Which technician is correct?

A) Technician A B) Technician B C) Both technicians D) Neither technician


A

Trades & Technology

You might also like to view...

When specifying the length and spacing of intermittent edge welds, the dimensions are placed to the ____ side of the weld symbol.

A. bottom B. top C. right D. left

Trades & Technology

Detailed drawings created by structural CAD technicians are essential for designing, fabricating, manufacturing, and erecting the structural products that go into a job. What type of drawings should be implemented to provide this information?

A. Engineering drawings B. Shop drawings C. Comprehensive drawings D. Inclusive drawings

Trades & Technology

A fuel pump is being replaced for the third time. Technician A says that the gasoline could be contaminated. Technician B says that wiring to the pump could be corroded. Which technician is correct?

A) Technician A only B) Technician B only C) Both technicians D) Neither technician

Trades & Technology

What is the reflected resistance seen by the primary in Figure 14-1 if the turns ratio is 3:1 and IS is 240 mA?

A) 9000 ? B) 1500 ? C) 167 ? D) 500 ?

Trades & Technology