The only difference between an isometric drawing and an isometric projection is the ____.
A. terminology
B. representation
C. size
D. both a and b
E. none of the above
Answer: C
You might also like to view...
Technician A says the ball joint is pressed into the lower control arm in some independent rear suspension systems. Technician B says when tightening the lower control arm to chassis retaining bolts on independent rear suspension systems, the vehicle weight should be resting on the tires. Who is correct?
A. A only B. B only C. Both A and B D. Neither A nor B
En la Figura 5, la finalidad de los contactos normalmente cerrados M1 que se muestran en el circuito de control implica:
a. proporcionar memoria para el interruptor START.
b. evitar el funcionamiento de la bomba de drenaje cuando la bomba de llenado está en
funcionamiento.
c. evitar el funcionamiento de la bomba de llenado cuando la bomba de drenaje está en
funcionamiento.
d. proporcionar memoria para el interruptor flotante.
A track rod is also called a ________
A) Semi-independent rod B) Control rod C) Handling link D) Panhard rod
?Which of the following is not true of section lines.
A. ?They should be evenly spaced by eye. B. ?They must be of uniform thickness. C. ?The average spacing used for most drawings is 3mm. D. ?They are generally drawn at 60 degrees to the horizon.