____ fits are typically associated with selective assembly.

A. Interference
B. Transition
C. Clearance
D. Bilateral


Answer: B

Trades & Technology

You might also like to view...

____ machines are adjusted by turning a handwheel that moves the internal parts closer together or farther apart.

A. Movable coil B. Tap type C. Inverter D. Transformer

Trades & Technology

When inspecting a transmission pan, what should be done?

A) Turn the pan upside down and check for particles that are stuck B) Use a magnet and check for any steel particles C) Wash the pan and then look for anything stuck to the bottom D) None of the above

Trades & Technology

It is important to clean dross and carbon deposits from a cut surface before welding because they can _____

a. produce extremely hazardous fumes during welding b. form hard, brittle zones and porosity in the weld zone c. damage certain welding equipment components d. cause molten metal to be blown considerable distances

Trades & Technology

If you are unavoidably late for an appointment, you should _____

a. immediately start work without talking to the customer b. apologize to the customer for your tardiness c. blame your tardiness on the company dispatcher d. ignore the fact that you are late and hope the customer does the same

Trades & Technology