Which of the following statements is LEAST-Likely true?
A. In a transmission, bearings support the ends of almost all rotating parts.
B. The input shaft is usually a single part made up of a series of gears that mesh with the various gears on the mainshaft.
C. Bearings allow parts to rotate with very little friction.
D. Different parts of the geartrain are commonly called "shafts."
Answer: B
You might also like to view...
There are several different names in use for the ABS controller. All of the following names have been used except:
a. EBCM b. ICU c. BACU d. CAB
What is usually considered to be the maximum recommended length for a single-piece driveshaft operating at speeds of 3,000 rpm?
A. 50 inches (127 centimeters) B. 70 inches (178 centimeters) C. 90 inches (228 centimeters) D. 95 inches (240 centimeters)
To append new lines in sed, you must use the ____ command
A. a\ B. -a C. \a D. >a
Go through each line of MATLAB code and show the result, or indicate if error will occur by executing the commands.
X=[ 4 5 -2 8];
Y=[2 0 1 10];
Z=(X