Freehand cuts should be made as clean and _____ as possible.?
 

A. rounded?
B. square?
C. vertical?
D. horizontal?


Answer: B

Trades & Technology

You might also like to view...

When disassembling a clutch pack a ________ is usually a required tool.

A) Leather glove B) Spring compressor C) Small hammer D) Chisel

Trades & Technology

Surging can cause (select all that apply):

a. seal leakage b. vibration c. destruction of the machinery d. deadheading conditions

Trades & Technology

Technician A says the information presented in the following figure is based on recommendations from the Rubber Manufacturers Association. Technician B says one of the two diagrams can be found on the vehicle's tire placard. Who is correct?

A. A only B. B only C. Both A and B D. Neither A nor B

Trades & Technology

The three types of loads a bearing must deal with are:

What will be an ideal response?

Trades & Technology