Slip-form paving machines can place pavement at a rate of between _____.

a. 3 to 5 feet per minute
b. 6 to 12 feet per minute
c. 16 to 20 feet per minute
d. 24 to 28 feet per minute


Answer: B

Trades & Technology

You might also like to view...

____ is usually accompanied by a small frog.

A. A fracture B. A club foot C. Ringbone D. A contracted heel

Trades & Technology

A pending code is one that:

A. Has had one failure but has not had a second consecutive failure B. Has been repaired but has not been erased C. Has caused the MIL to illuminate D. Had met the criteria to illuminate the MIL but has not reoccurred

Trades & Technology

CMOS uses

A) n-channel and p-channel E-MOSFETs B) E-MOSFETs and D-MOSFETs C) n-channel and p-channel D-MOSFETs D) dual-polarity supplies

Trades & Technology

Technician A says the bare metal should be cleaned with wax and grease remover before applying conversion coating to prevent rust. Technician B says that a plastic paint cup or paint cup liner should be used to prevent acid etch primer from harming a steel paint cup. Who is correct?

A. Technician A only B. Technician B only C. Both Technicians A and B D. Neither Technician A nor B

Trades & Technology