When using Plastigage to check bearing clearances, a wider compressed gauge material indicates a ________
A) Smaller oil clearance B) Larger oil clearance
C) Smaller side (thrust) clearance D) Old plastic gauging material
A
You might also like to view...
A technician has found a DTC C0310. Which component of the transfer case should be inspected?
A) Front speed sensor B) Motor circuit A/B C) Rear speed sensor D) The module ground
Total sales is given by the formula: R = Q x P. What does Q represent?
A. Price per unit B. Number of customers C. Number of units sold D. Quality
While having a discussion, Technician A says that if the timing is retarded, engine idle will be too high. Technician B says that if the timing is advanced, the idle will be too low. Who is correct?
A. A only B. B only C. Both A and B D. Neither A nor B
Which of the following conditions would be more likely to cause harsh upshifts in an Allison hydromechanical transmission?
A. mechanical modulator out of adjustment B. downshift points set high C. retarder cycling D. engine rated speed set low