Does that are in good physical condition can be rebred ______ weeks after kindling.
Fill in the blank(s) with the appropriate word(s).
Answer: 2
You might also like to view...
Answer the following statement(s) true (T) or false (F)
1. In most cases, when soldering a joint, very little solder is needed. 2. Characteristics of an overheated solder connection include de-wetting, lumps, dull, crystalline-like, and looks as though sand has been thrown into the joint. 3. When you are not using your iron, never leave a large lump of solder on the tip. 4. Flux prevents oxidation and removes the thin layer of oxide and the atmospheric gas layer from the area to be soldered. 5. Poor wetting is usually the result of poor cleaning procedures or lack of sufficient heat.
What does the step-down transformer do?
What will be an ideal response?
In commercial cylinders, a plastic or ____ seal is used to form a tight barrier to prevent fluid from escaping around the piston.
A. rubber B. brass C. steel D. aluminum
When entering a confined space:
A) You should wear clothes that are resistant to spontaneous arcing. B) You should take a radio or cell phone for emergency calls in case you pass out. C) Another worker should be posted outside the confined space. D) You should leave a note at the entry point.