Technician A says that valve lash can be adjusted on a cylinder that is at TDC and on the compression stroke. Technician B says that feeler gauges are used when adjusting hydraulic lifters. Who is correct?
A. A only
B. B only
C. Both A and B
D. Neither A nor B
Answer: A
Trades & Technology
You might also like to view...
Almost all nameplates will list the primary voltage, secondary voltage, and ____.
a. serial number b. impedance c. KVA (kilo-volt-amps) rating d. temperature rise
Trades & Technology
When referring to thermocouples, the hot ____________________ is at a higher temperature level than the cold ____________________.
Fill in the blank(s) with the appropriate word(s).
Trades & Technology
Which of the following front-end angles is defined as the forward or rearward tilt of the kingpin centerline when viewed from the side of the vehicle?
A. Camber B. Caster C. Toe D. Kingpin inclination
Trades & Technology
In HI-Z mode, data from the bus cannot be loaded to or retrieved from a D flip-flop
Indicate whether the statement is true or false
Trades & Technology