Where are the drawing number and revision level found?
a. In the zoning coordinate system.
b. In the title block.
c. In the bill of material
d. On the back of the drawing.
b. In the title block.
You might also like to view...
Identify the single most significant development in (a) manufacturing technology, (b) transportation, (c) communications technology, and (d) business organization that encouraged industrialization in the United States. Explain your choice in each category.
What will be an ideal response?
Two technicians are discussing orifice tubes. Technician A says the OT may be located close to the evaporator inlet. Technician B says the OT is placed close to the condenser in some vehicles. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians D) Neither technician
The anchor shown is called a(n) _____.
a. sleeve anchor
b. toggle bolt
c. expandable anchor
d. drive anchor
Find the circumference of a 3 3/16-inch diameter circle to the nearest thousandth of an inch.
A. 10.014 B. 10.524 C. 10.655 D. 11.001