Which of the following is true of the lap joint?
A. The filler rod should be added to the bottom sheet.
B. Heat is not distributed uniformly in the lap joint.
C. If the rod is added directly into the notch, the weld strength will be affected.
D. The flame must be directed at the top sheet and away from the bottom sheet.
Answer: B
You might also like to view...
In a steam system, insulation is not normally applied to _____.
a. main steam piping b. turbine casings c. steam traps d. boiler feedwater pumps
Silastic-LC-50 is a liquid silicon rubber designed to provide excellent clarity, superior mechanical properties, and short cycle time for high speed manufacturers. One high-volume manufacturer used it to achieve smooth release from molds. The company’s projected growth will result in silicon costs of $26,000 in years 1 and 2, with costs increasing by $2000 per year in years 3 through 5. At an interest rate of 10% per year, what is the present worth of these costs?
What will be an ideal response?
The two most common pollutant pathways are:
A) Through ventilation ducts and building infiltration. B) Through leaky return air ducts and building infiltration. C) Outside to inside and from one area inside to another area inside. D) From equipment surfaces and through infiltration.
The speed of a moving coil motor (MCM) is varied by __________.
A. changing the DC voltage applied to the armature B. changing the width of DC pulses applied to the armature