The most common fillet welds made are in _____
a. lap and T-joints
b. horizontal joints
c. overhead joints
d. vertical joints
a
You might also like to view...
The jack shown in the figure above is a(n) _____.
a. screw jack b. toe jack c. bottle jack d. ratchet jack
What are the steps involved in the use of a ridge remover tool?
What will be an ideal response?
How are the indoor sections of mini-split heat pump systems normally installed?
A) They are mounted on the ceiling or hung on a wall. B) The indoor section is installed in an attic or basement and ducted to the conditioned space. C) They are mounted in a window with the refrigerant lines running out the back. D) A large hole must be cut in an outside wall and extra framing added to support the unit.
Engineered wood products are considered an efficient use of raw material. True or false?
Indicate whether the statement is true or false