Describe the practice of showing the multiviews of the part representing the final bent condition, and the flat pattern reference drawn on one of the views using phantom lines.
What will be an ideal response?
This option for a sheet metal part is for the multiviews of the part representing the final bent condition, and the flat pattern reference drawn on one of the views using phantom lines. For example, a multiview drawing of a final bent sheet metal part dimensioned using unidirectional dimensioning. The flat pattern reference is shown extended from the front view using phantom lines and is labeled for reference. This application is an option used by some companies, but it is one of the least common methods for drawing a sheet metal part.
You might also like to view...
All of the following are accurate descriptions of the young American nation EXCEPT
A. its population was still about 90 percent rural, despite the flourishing cities. B. the first official census of 1790 recorded almost four million people. C. all but five percent of the people lived east of the Appalachian Mountains. D. most of the population lived in the eastern seaboard cities. E. foreign visitors looked down at the roughness and crudity of the pioneering life.
The only downside of fertilizer overapplication is the wasted expense
Indicate whether the statement is true or false.
A 2.7L engine operates with an MEP value of 165 psi at 3000 RPM. Determine the indicated torque, and round to the nearest whole unit
What will be an ideal response?
The correct lighting procedure for an oxyacetylene torch is:
A) Crack the acetylene and light it first, then add the oxygen. B) Crack the oxygen and light it first, then add the acetylene. C) Fully open both the acetylene and oxygen, wait 30 seconds, and then light the mixture. D) Crack both the acetylene and oxygen and light the mixture.