How is placement of the compressor line determined when drawing a PH diagram of an operating system?
A) The compressor line starts where the evaporator line crosses the suction line temperature and follows the constant entropy lines up until it crosses the condenser line.
B) The compressor line starts where the evaporator line crosses the suction line temperature and follows the constant quality lines up until it crosses the condenser line.
C) The compressor line starts where the condenser line crosses the suction line temperature and follows the constant entropy lines up until it crosses the evaporator line.
D) The compressor line starts where the evaporator line crosses the suction line temperature and follows the constant enthalpy lines up until it crosses the condenser line.
A
You might also like to view...
How long are four of these weldments, in inches?
Reduce all fractions to their simplest forms. Convert all improper fractions to mixed numbers. Provide answers in the following format:
Fraction: 3/4
Mixed number: 1 5/8
The weight of a standard transmission flywheel is equal to the weight of an automatic transmission flexplate.
Answer the following statement true (T) or false (F)
Stress risers are most detrimental when they are located on the _____.? ?
A. groove? B. notch? C. weld pass? D. surface?
When should DTCs be cleared?
A) After the repair has been verified B) After the problem has been verified C) After pinpointing a problem cylinder D) After consulting TSBs