Program the hole locations of the part drawing in the accompanying figure. The location dimensions given in the table are taken from drawings before programming for CNC. The origin (0, 0) used for programming is shown on the drawing. Use the hole location dimensions in the table to write program hole locations. Write the program hole locations (coordinates) in table form using a) absolute positioning and b) incremental positioning

What will be an ideal response?



Trades & Technology

You might also like to view...

72 kg of air moves at a speed of 4.9 m/s.  How much kinetic energy does this mass of air have??

Fill in the blank(s) with the appropriate word(s).

Trades & Technology

Most types of concrete slabs that are totally supported by the ground beneath them are _____.

a. monotonous b. lithotropic c. dendritic d. monolithic

Trades & Technology

The volume of ________ is subject to the greatest amount of change when there is a change of pressure and temperature

A) a liquid B) a solid C) a gas D) a condensate

Trades & Technology

When troubleshooting a residential heating system, the technician reads 24 volts at the gas valve on a call for heat, but the gas valve does not energize. What would be the most likely problem?

A. defective gas valve B. defective thermostat C. defective transformer D. blown low-voltage fuse

Trades & Technology