The ____ is normally replaced any time the clutch is apart.
A. release bearing
B. slave cylinder
C. clutch fork
D. clutch disc
Answer: D
You might also like to view...
Technician A says that a starter motor which draws excessive current and has low cranking speed could be caused by an internal engine problem. Technician B says that excessive cranking circuit resistance can cause low cranking speeds. Who is correct?
A. A only B. B only C. Both A and B D. Neither A nor B
A scale that reads 1:2 is a(n):
A. architect's scale B. metric scale C. civil engineer's scale D. full scale E. half scale
Setting the amperage at 200 amps for a welding machine that is rated 300 amps at 60-percent duty cycle will
_____. a. reduce the shielding gas flow rate by 30 percent b. cause excessive nozzle vibration c. increase the duty cycle to 100 percent d. allow welding current to be pulsed
Auxiliary contacts are usually rated at a lower amperage than the contactor's primary contacts.
Answer the following statement true (T) or false (F)