In an open-root V-groove pipe weld, root reinforcement depth should be kept flush or at a maximum of
_____.
a. 1/32" (1 mm) in depth
b. 3/32" (2 mm) in depth
c. 1/8" (3 mm) in depth
d. 3/16" (5 mm) in depth
c
Trades & Technology
You might also like to view...
All of the following are measurements of engine horsepower EXCEPT:
A. brake horsepower B. indicated horsepower C. frictional horsepower D. dyno horsepower
Trades & Technology
What is the leading cause of intermittent electrical signal issues?
What will be an ideal response?
Trades & Technology
Which method can be used to reprogram a PCM?
A) Remote B) Off-board C) Direct D) All of the above
Trades & Technology
When using GTAW on carbon steel pipe in the 1G-ROTATED position, run all passes at or near a point
_____. a. at the top of the pipe as it rotates b. at the bottom of the pipe as it rotates c. that is 45 degrees from the top of the pipe d. that is 90 degrees from the bottom of the pipe
Trades & Technology