An advantage of transfer molding is that the molten mass is ____when entering the mold cavity, allowing for fragile, complex shapes with inserts or pins to be formed with accuracy.?
A. ?viscous
B. ?premixed
C. ?fluid
D. ?preformed
Answer: C
You might also like to view...
Technician A says the flywheel and pressure plate assembly both rotate at engine crankshaft speed when the engine is running. Technician B says when the engine is running, and the transmission is in neutral, the transmission input shaft may be either rotating or at rest, depending on the clutch pedal position. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians A and B D) Neither technician A nor B
____ line dimensions simplify the reading of a drawing and also permit greater accuracy in making the part.
A. Staggered B. Relative C. Circle D. Base
Three-phase voltages are _____ out of phase with each other.
A. 80° B. 90° C. 100° D. 120°
Simplify the following ratio.
Fill in the blank(s) with the appropriate word(s).