The thread specification on a drawing should include:

A. The number of threads per inch
B. The thread series
C. The thread form
D. All of the above


Answer: D

Trades & Technology

You might also like to view...

What is a section at the bottom of a process vessel where water or other unwanted fluid is collected and removed?

A) Weir B) Boot C) Baffle D) Vane separator

Trades & Technology

In agricultural buildings that require equipotential planes, the equipotential plane must be bonded to the grounding system with a bare or insulated solid copper wire no smaller than _____.

a. No 8 AWG b. No 6 AWG c. No 4 AWG d. No 3 AWG

Trades & Technology

Assume the total resistance in a series circuit is 12 ohms and the circuit is powered at 100 volts. Calculate the current for this circuit.

What will be an ideal response?

Trades & Technology

The layout of a hip roof is similar to the layout of a gable roof. Only the upper line of the roof will remain, but the other lines are needed to determine the location of the ____.

A. eave B. cornice C. rake D. fascia

Trades & Technology