The kit that will MOST-Likely include gaskets, piston rings, crankshaft bearings, and sometimes, a timing set, is the:
A. crankshaft kit
B. timing chain set
C. master kit
D. overhaul kit
Answer: D
You might also like to view...
What does a circle indicate on a Process Flow Diagram?
What will be an ideal response?
Computer investigation of wind load on a building frame.
Case 1: The columns and girders of the rigid building frame in Figure P5.58 have been
designed initially for vertical load as specified by the building code. Floor beams are
connected to columns by rigid joints. As part of the design, the building frame must be
checked for lateral deflection under the 0.8 kip/ft wind load to ensure that lateral displacement
will not damage the exterior walls attached to the structural frame. If the code requires that
the maximum lateral deflection at the top of the roof not exceed 0.48 in. to prevent damage to
the exterior walls, is the building frame sufficiently stiff to satisfy this requirement?
Case 2: If the bases of the columns at point A and F are attached to the foundations by fixed
supports instead of pin supports, how much is the lateral deflection at joint D reduced?
Case 3: If a pin-connected diagonal bar bracing with a 2 in. × 2 in. square cross section
running from support A to joint E is added, determine the lateral deflection at joint D. Assume
pin supports at joints A and F.
For the columns, I = 640 in. 4 and A = 17.9 in.2; for the girders, I = 800 in. 4 and A = 11.8 in. 2 ;
for the diagonal brace, A = 4 in. 2 . Use E = 29,000 ksi.
The only location where the refrigerant vapor is superheated is in the evaporator.
Answer the following statement true (T) or false (F)
?Which is a primary factor in sizing a wood-gasification boiler?
A. ?the physical space available B. ?the amount of available firewood C. ?the number of firing cycles per day the owner is comfortable with D. ?the availability and location of electricity at the site