To inspect loaded ball joints that do not have wear indicators, the technician must:
A. raise the vehicle and support the lower control arms as far outboard as possible.
B. raise the vehicle and shake the tire front and rear.
C. raise the vehicle and support the control arms as far as possible to the wheel assembly.
D. either A or C.
Answer: A
You might also like to view...
Explain how to read very low currents in a control circuit using a clamp-on amp meter.
What will be an ideal response?
The surface finish for the cylinder walls usually depends on ________
A) The cylinder wall-to-piston clearance B) The type of engine oil that is going to be used in the engine C) The type of piston rings to be used D) Both B and C
Technician A says that it is a good idea to recommend replacing upper strut bearings when replacing MacPherson struts. Technician B says that all MacPherson struts can be serviced by replacing the cartridge inside the strut assembly. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians D) Neither technician
Measuring velocity pressure in a duct indicates the ____.
A. volume of air through a duct B. speed at which the air is moving C. pressure against the sides of the duct D. weight of the air moving through the duct