In the above diagram, the tail is used to show __________.
A. parts to be welded
B. welding process
C. reference line
D. type and location of weld
Answer: B
You might also like to view...
A good analogy of the ____ control is a stack of pennies. This tolerance would control how round each penny is but not the straightness of the whole stack.
A. cylindricity B. concentric C. circularity D. flatness
PROBLEM 3.69
Determine the required thickness of the 50-mm tubular shaft of Concept Application 3.7 if it is to transmit the same power while rotating at a frequency of 30 Hz.
Technician A says that charging system testing requires that the battery be at least 75% charged. Technician B says that a digital multimeter can not be used to test charging system voltage. Who is right?
A) Technician A only B) Technician B only C) Both technicians A and B D) Neither technician A nor B
What type of noise will be caused by a piston slap?
A. A sharp, metallic rapping noise that occurs with the engine idling. B. A hollow, bell-like noise that is most often occurring during cold engine warmup C. A light, rapping noise at speeds above 35 mph. D. A heavy thumping knock when the engine is first started