What is the title of the drawing?
Review drawing number 523797C0A and then answer the question.
BOOM DRIVE ASSEMBLY FOR 800 SERIES MANIPULATOR
You might also like to view...
What should be done when checking the refrigerant charge of an operating packaged unit?
a. Allow time for the operation of the unit to stabilize. b. Put the unit in economizer mode. c. Open all outdoor air dampers and close the return air dampers. d. Remove the supply air fan access panel.
What is the area between the parallel walls of the compressor cover and bearing housing where the air leaves the wheel?
A. the inducer B. the spool C. the volute D. the diffuser
The following statements are all correct EXCEPT ________
A) Waste-spark systems use a signal from the PCM once the engine is running. B) Waste-spark systems do not need a timing signal from the PCM when cranking the engine. C) No ignition system uses the PCM to control ignition timing. D) Up-integrated ignition controls use the PCM to control ignition timing.
Heat intensity refers to which of the following?
A) The amount of heat in an area B) The number of Btu in an area C) The heat individuals feel D) None of these