Which of the following is a critical factor in the strength of the truss?
A. Joints
B. Bar joist
C. Stiffening
D. Connectors
Answer: D. Connectors
You might also like to view...
When replacing a transaxle, correct unit identification is critical because the ________ may be different, depending on the application or engine size of the vehicle.
A) Case material B) Fluid color C) Rubber seal material D) Final drive ratio
The total indicated runout (TIR) of a ring gear should be ________.
A) 0.020 inch (0.5 mm) B) 0.040 inch (1.0 mm) C) 0.200 inch (5.0 mm) D) 0.002 inch (0.05 mm)
What type of motor turns slightly slower than the supplied frequency and can vary in speed based on the amount of load?
A. DC motor B. Universal motor C. Induction motor D. Synchronous motor
In a typical DC electric braking circuit, power is supplied to the braking relay by a(n) _____.
a. NOTC contact b. NCTO contact c. NOTO contact d. NCTC contact