Where can a tolerance on an angular dimension be given in a drawing?
What will be an ideal response?
The tolerance on an angular dimension may be given in a note on the drawing, as shown in. The tolerance may also be shown on the angular dimension itself.
You might also like to view...
NEC Chapter 5 contains _____.
a. requirements for communications systems b. information on special equipment c. information on special occupancy areas d. requirements for overcurrent protection
What is the nominal and actual depth of a W18 40 structural steel rolled shape?
What will be an ideal response?
A square-wave generator produces the voltage waveform shown in Fig. 6.94(a). What kind of a circuit component is needed to convert the voltage waveform to the triangular current waveform shown in Fig. 6.94(b)? Calculate the value of the component, assuming that it is initially uncharged.
 FIGURE 1.png)
The direction of the rotor can be reversed by changing the position of ____________________.
Fill in the blank(s) with the appropriate word(s).