Technician A says the same areas used as the control points for repair purposes are used by the manufacturer as holding fixture locations. Technician B says the center plane is used to take side-to-side measurements. Who is correct?
A. Technician A only
B. Technician B only
C. Both Technicians A and B
D. Neither Technician A nor B
C. Both Technicians A and B
You might also like to view...
Where can you find a replacement finger for a badly damaged edge connector?
What will be an ideal response?
Which of the following is the part of the drainage system located outside of the building that conveys storm water or other drainage, but no sewage?
a. building storm sewer b. roof drain c. scupper drain d. foundation drain
The bottom plate in a WLF wall is called
A) a sill plate. B) a sole plate. C) A and B are synonymous terms. D) either A or B, depending on the location of the wall.
____ contain: orthographic views of the column; locational dimensions for plates, angles, and holes; length dimensions; the baseplate configuration; connection specifications; and miscellaneous notes for the fabricator.
A. Beam fabrication details B. Column fabrication details C. Cross section fabrication details D. Longitudinal fabrication details