A typical IAT or ECT sensor reads about 3000 ohms when tested using a DMM. This resistance represents a temperature of about ________
A) 284° F (140° C) B) -40° F (-40° C) C) 120° F (50° C) D) 70° F (20° C)
D
You might also like to view...
What is formed in the heat exchanger of a high-efficiency furnace that requires a drain?
What will be an ideal response?
What material should clothes worn during welding be made of?
A) A polyester, nylon, acetate blend B) 100% Cotton C) 65% polyester - 35% nylon D) 100% polyester
Is it possible for a K-map to have two equally good solutions with each solution being dependent on how the 1s are looped?
A) Yes B) No
Which of the following statements regarding the mechanical-draft cooling tower is correct?
A) The mechanical-draft cooling tower uses a fan to move air through the tower. B) Mechanical-draft cooling towers are used only for small-scale installation requiring a few gallons of water per minute. C) The primary means of drawing air though the mechanical-draft cooling tower is the density difference between the air inside and outside the tower. D) There is only one design for a mechanical-draft cooling tower–the hyperbolic design.