What is the minimum width of support straps used to hang flexible ducts?
a. 1/4 inch
b. 1 inch
c. 1-1/2 inches
d. 2 inches
c. 1-1/2 inches
You might also like to view...
A flat-bottomed hole is milled in this retainer cap. The hole is 7 cm in diameter and 20 cm deep. What is the volume of the cap, in cubic centimeters, after the milling operation? Express the answer to the nearest thousandth.
A large corporation will often publish an addendum to ASME or ISO standards. List the four items the addendum typically covers.
What will be an ideal response?
Before installing or starting a new or rebuilt engine, all of the following items should have been checked, EXCEPT ________
A) Pre-lube engine and check for proper oil pressure B) Check that all of the vacuum lines are correctly installed and routed C) Rear axle is topped off D) Battery fully charged
Technician A says that the cooling system should be tested for leaks using a pressure-operated pressure pump. Technician B says the freezing and boiling point of the coolant can be tested using a thermometer. Which technician is correct?
A) Technician A B) Technician B C) Both technicians D) Neither technician