The partial circles or holes in back of the openings of a standard sheet metal gage are ____.
A. for clearance purposes only
B. to measure clearances
C. to measure the thickness of sheet or plate, or the diameters of wire
D. to determine the type of steel
Answer: A
Trades & Technology
You might also like to view...
Dimensions
What will be an ideal response?
Trades & Technology
Complete the table shown in Figure P7–7.
What will be an ideal response?
Trades & Technology
The concrete form accessory shown in the figure is a _____.
a. spacer
b. form tie
c. waler
d. spreader
Trades & Technology
After determining that voltage is available to the control circuit of a residential air-conditioning system, what four devices should be checked when troubleshooting the system?
What will be an ideal response?
Trades & Technology