How many thousandths of an inch of material should be left for a finishing cut, when roughing out a cavity?
A) .010 B) .030 C) .060 D) .080
B
You might also like to view...
Refer to the figure above. What is the total load a feeder serving four 2hp motors, three 5hp motors, one 15hp motor, and one 25hp motor? All motors are 208V.
a. 50A b. 145.2A c. 201.1A d. 219.8A
Which of the following is an incorrect statement about the use of a shackle?
a. Shackles with pins worn more than 10 percent should be replaced. b. A shackle pulled out at an angle has a reduced capacity. c. A shackle should never be used such that the pin can roll under load. d. When using a shackle with a hook, the shackle body should be hung on the hook.
? Lincoln-Douglas debates
What will be an ideal response?
What were the situations or advantages which convinced some owners to use FRP in the past as a greenhouse covering?
What will be an ideal response?